Contact Us

CHENGCHUANG INDUSTRIAL LIMITED

ADD:2205#, 31th Building, XiangZhangLuZhou, ZhangMuTou Town,Dongguan City,Guangdong Province, China 523622

Tel:0769-82017148

Fax:0769-82017780

E-mail:ken.tang@chengcg.com

Search
Position:Home > News > Company News

The operation process of laser cutting machine

2018/7/12 21:24:56 Viewers:
1. observe the safety operation rules of the general cutting machine. Start the laser in strict accordance with the laser startup program.
2. operators must be trained, familiar with the structure and performance of the equipment, and master the relevant knowledge of the operating system.
3. wear protective clothing according to regulations, and wear protective glasses that meet the requirements near the laser beam.
4. before making sure that a material can be irradiated or heated by laser, do not process it, so as to avoid the potential danger of smoke and steam.
5. when the equipment is started, the operator shall not leave the post without authorization or wait for the management. If he really needs to leave, he should stop or cut off the power switch.
6. put the fire extinguisher in a convenient place; turn off the laser or sluice when it is not processed; do not place paper, cloth or other flammable objects near the unprotected laser beams.
7. in the process of finding abnormal, the machine should be shut down immediately, troubleshooting promptly or reporting to the supervisor.
8. keep the laser, bed and surrounding areas clean, orderly and free from oil pollution. The workpiece, board and waste are stacked according to regulations.
9. when using gas cylinders, avoid damaging the welding wires, so as to avoid leakage accidents. The use and transportation of cylinders should comply with the gas cylinder monitoring regulations. It is forbidden to explode or close to the heat source under the sun. When opening the bottle valve, the operator must stand on the side of the bottle mouth.
10. the high pressure safety regulations should be observed during maintenance. Each operation for 40 hours or weekly maintenance, 1000 hours per operation or six months' maintenance shall be carried out in accordance with regulations and procedures.
11. after starting, manual low speed X and Y direction should be started to check the machine and check whether there is any abnormal condition.
12. after the new workpiece program is input, it should be run first and check its operation.
13. when working, pay attention to observing the operation of the machine tool, so as to prevent the cutting machine from getting out of the effective travel range or causing collision accidents in two units.